Welcome to the RF lab

Part of the Measure & Test Centre (MTC)

In the RF Lab you can electronically measure/test over a wide frequency range (DC-50 GHz) circuits (IC) and systems on state-of-the-art equipment. For instance parameters like Noise Figure, Phase-Noise, IPx, S,X,Z,Y, Jitter as well as DC parameters can be measured. System design parameters like BER, EVM and THD parameters can also be determined.  

All can be handled on wafer/die level or packaged. Some impressions of our Lab:

Semi-automatic Probestation PA200 w. ATT temp control (-40 to +300 C)

Typical analog test setup to measure specific parameters

Measuring a Die mounted on a PCB 

Most of the instruments in our Lab have their own controller (Windows based) or are controlled by PC's (Windows 7 and still some under XP), so measurements can be carried out automatically as well as manually. All controllers are configured in a network, this enables us to easily exchange all the measured/simulated results for pre/post processing with programs like e.g. MATLAB, LabVIEW, VSA89600B, ADS, etc...

To measure very low signals it is possible to measure it in a "Faraday Cage" to isolate you from the external free space EM radiated powers.

If you wish to measure e.g. your antenna characteristics (transmitted and received) we can offer you to make use of an anechoic room.



At our ICD chair we use some of our equipment also for educational purposes in our Master Courses like Microwave Techniques (191211720). During this course students use a networkanalyzer and power meter together with Agilent ADS to compare measurements with ADS-simulations. For assignment details, see the Lab Manual.  

Furthermore a Msc-Course WTE (Wireless Transceiver Electronics) (191211500) is offered where insight in the operation and design of wireless transceiver electronics is presented. The final examination concerns a design assignment that includes deriving circuit specifications from radio system specifications, designing a receiver circuit block and simulating of its performance using state-of-the-art industrial simulation software (SpectreRF, Agilent's VSA89600 and Advanced Design System (ADS)).


What's New

A list of recent investments in our Lab.

  • Keysight Vector Signal Generator E8267D, frequency range: 250kHZ - 44 GHz.
  • An Keysight Digital Oscilloscope DSZ204a, 4 channels 20 GHz analog bandwidth (80 Gsa/s)
  • The Keysight E5061B Vector Network Analyzer / Impedance Analyzer @ 100kHz-3GHz / 5Hz-30MHz (replaces the HP4194A Gain-Phase Impedance Analyzer)

Whenever we expand our Lab with new instruments and/or software, we'll put this notice here above. Each item is linked to the page with the updated content.


For visitors who have questions about our RF Lab facilities and the possibilities to use these facilities for their own specific test/measurement problem(s), please feel free to contact:

Henk de Vries